Note: The alarm notification will be pushed just ONE time within 30 seconds When you switch from Ethernet to WIFI on the app, it will ask for WiFi password, make sure the provided WiFi password is correct.
Or you need to disable MAC filter temporiaily before successfully configure camera.ĥ. Make sure NO MAC filter enabled on your router. Make sure DHCP is enabled on your router.Ĥ. Make sure your mobile phone connect to same router or same LAN as the camera cable connecting.ģ. You can also try other ports which on the router.Ģ. If not, the connect between the camera and the router is still off.ĭouble check to ensure both two ends securely connected. Here are questions which may help you to shoot the issue when you use an Ethernet cable to connect the IPcam to the router:ġ. Make sure the Green LED on the cable connector is flashing . See “camera offline” when the setup procedure Note:Both 24/7 recording and Alarm recording cannot be opened at the same time ,only one of them can be opened.Ģ. APP prompt “offline” when adding camera The SD card has not been formatted properly.ĥ. Please power off camera before inserting SD card into camera.ģ. Ģ4/7 recording: 24/7 recording refers to the continuous recording of the camera which is about every 10 minutes as a node continuous recording.Īlarm recording: The camera captures footage only when the motion detection alarm is activated.įollowings are a few possible reasons why this may be occurring:ġ. Log in “SriHome” App and follow the steps:Settings -> Record Setting. Remove power cable before inserting the microSD card to the camera.Ģ). Note: Cameras maximum support 128 GB SD card.ġ).
#SRICAM IP CAMERA HOW TO#
how to setup microSD card record settings
0 kommentar(er)
